Printed effector with threaded ball ends

This component is in alpha state.

Effector with M3 threads

Using the effector_ball_ends.stl printed effector plate, you can use any type of M3 threaded ball ends. For repurposing the stock arms, it is recommended to use 8mm stainless steel balls with an M3 thread and 10mm M3 set screws to connect them to the effector plate.

Required parts

Type Variant Amount Unit Stores
Effector 1 Ball ends 1 print stl/effector/effector_ball_ends.stl
Heat set insert M3x5x4mm 8 piece HotXYZ
Hex set screw M3x10mm 6 piece Electrician House
Ball end 8mm with M3 thread 6 piece HongKai
Thread locker 2 Medium/Strong 1 piece  

  1. Printed parts can be found in the DeltaWerken/SuperRacer repository ↩

  2. Thread locker is recommended to secure the set screws in the ball ends and joints ↩